Step-by-step instructions
Step 1
Measure the bathroom wall, fixture clearances, walking path, and intended towel or basket loads.
Step 2
Set the ladder angle and rung spacing on a full-size layout so the feet and top land safely without contacting plumbing fixtures.
Step 3
Cut rails and rungs, drill controlled pilot holes, and dry-assemble on a flat surface.
Step 4
Glue and fasten square, ease every edge, and add non-slip feet suited to the floor finish.
Step 5
Apply a moisture-resistant finish to all faces and end grain and allow full cure.
Step 6
Place the ladder outside wet splash zones where practical and secure it with a removable wall restraint into verified support.
This is storage, not a climbing ladder. Keep it away from electrical sources and direct shower spray, use non-slip feet and a wall restraint, and verify hidden utilities before fastening.
