Step-by-step instructions
Step 1
Measure appliance width, vibration clearance, control access, door swing, hoses, vents, receptacles, and required service space.
Step 2
Choose a removable or supported counter design that does not rest on appliances unless the manufacturers explicitly permit it.
Step 3
Locate framing and utilities, then cut the counter and supports to preserve ventilation and service access.
Step 4
Seal all faces and edges, especially around utility penetrations, and allow the finish to cure.
Step 5
Install level cleats or cabinet supports into verified framing, then secure the counter against movement without trapping appliances.
Step 6
Run a full appliance cycle while observing vibration, heat, hose movement, and counter clearance before normal use.
Laundry areas contain water, electricity, gas, heat, and moving appliances. Shut off relevant utilities before moving appliances, preserve manufacturer clearances and venting, and consult licensed professionals for gas, wiring, plumbing, or structural uncertainty.
